FINISHING PRODUCTS
Exposé Surface Retarders
Exposé Surface Retarders
Exposé is a spray-applied, ready-to-use chemical surface retarder. It allows you to create beautiful exposed aggregate finishes by delaying the set of the surface of freshly poured concrete while allowing the rest to cure normally.
Exposé is water-based, economical and easy to use. It provides uniform aggregate exposure and consistent results without the use of machinery or cumbersome covers. Exposé is available in a variety of color-coded depths of etch, from a light sand exposure to full exposure of 5/8 inch (13mm).
Can Be Used on:
Driveways
Sidewalks
Patios
Pool decks
Curbs
Roadways
Important: The colors shown here are presented only as a guideline, and should not be used to make your final color selection. Computer screens and printers vary greatly and cannot accurately show the colors that will be obtained. The samples pictured here were developed in a controlled environment using materials that vary in different geographic locations. A mockup is highly recommended to make sure the colors you choose meet your expectations.
To obtain a professionally printed color chart or samples of colored concrete, please contact Customer Service at tcocsales@gmail.com or visit our 'contact page' to send us a message.
